Roofing, siding and metal building materials for contractors, builders and designersServing the U.S.
Home › Resources › Through-fastened vs standing seam

Through-fastened vs standing seam

The two main types of metal roof differ in how they're fastened, how they look, what they cost and how much upkeep they need.

crew installing metal roof panels

The short answer

Through-fastened panels are screwed straight through the face of the panel into the deck or framing. They cost less and install faster. Standing seam panels hide their fasteners under a raised seam. They cost more, look cleaner and need less upkeep over the life of the roof.

Side-by-side

Through-fastened Standing seam
Fasteners Exposed screws with rubber washers Hidden clips or a concealed flange
Look Ribbed panels, visible screw lines Clean, flat panels with tall seams
Typical gauges 29, 26, 24 26, 24, 22
Typical minimum pitch 1:12 to 3:12 by profile ¼:12 to 3:12 by system
Thermal movement Limited; screws hold the panel fixed Clips allow the panel to expand and contract
Maintenance Check and replace worn screws every 10 to 20 years Little routine maintenance
Material cost Lower Higher
Labor Faster, simpler Slower; mechanical seam needs a seamer
Common uses Barns, shops, metal buildings, budget homes Architectural homes, commercial roofs, low slopes

Typical ranges; exact figures vary by product.

When through-fastened makes sense

  • Agricultural buildings, shops, garages and sheds
  • Metal buildings over open purlins
  • Re-roofs on a budget
  • Walls and siding, where exposed screws matter less

When standing seam makes sense

  • Homes where appearance matters
  • Low-slope roofs, where the raised seam keeps water out
  • Long panel runs, where thermal movement adds up
  • Owners who want a roof with less maintenance
  • Roofs that will get snow guards or solar panels, which can clamp to the seams without holes

Cost over the life of the roof

Through-fastened roofs cost less up front. Over 40 years or more, they need periodic screw checks and replacements, which add labor. Standing seam costs more up front but has fewer leak points and less upkeep. For a building you'll keep a long time, compare the total cost, not just the first price.

Related