Roofing, siding and metal building materials for contractors, builders and designersServing the U.S.
Home › Services › Cut-to-length ordering

Cut-to-length ordering

Metal roofing, standing seam and siding panels ordered to the exact lengths your job needs, so there's less cutting and less waste on site.

panels labeled by length

How it works

Metal panels are usually made to order. Instead of buying stock lengths and cutting them down, you send a cut list: each panel length and how many of each. The panels are made to those lengths and labeled for the job.

Benefits:

  • Less cutting on site, which saves labor and protects the paint and coating at the panel ends
  • Less waste and less scrap to haul away
  • One continuous panel from eave to ridge on most roofs, with no end laps
  • Easier installation, because each panel goes where it was measured for

How to write a cut list

For each roof plane or wall:

  1. Measure the panel run from the eave (or bottom) to the ridge (or top), along the slope, not the horizontal distance.
  2. Add the overhang at the eave and any extra needed at the ridge, as the panel and trim details call for.
  3. Count how many panels the plane needs: divide the width by the panel's coverage width and round up.
  4. For hips, valleys and gables, list the longest panel each panel will be cut from.

Write each line as quantity × length, for example: 24 pcs @ 16′ 4″. Group by roof plane or wall so the order is easy to check.

Example cut list

Roof plane Quantity Length Notes
Front main roof 24 16′ 4″ Full-length panels
Back main roof 24 16′ 4″ Full-length panels
Porch roof 12 8′ 2″ Low-slope; check minimum pitch
Garage gable wall 14 Varies, up to 11′ 6″ Cut on site to the rake angle

Length limits

Very long panels are possible, but shipping and handling set practical limits. Panels much longer than a standard truck bed may need special delivery. Long runs also need clips or fastening that allows for thermal movement. Ask about long panels with your quote request.

Helpful tips

  • A roof measurement report gives slope lengths that make cut lists faster.
  • Order a few extra short panels for repairs and mistakes.
  • Keep panel labels until the job is done so each panel goes in the right place.

Common questions

Do you supply stock lengths too?

Yes. Some panels and most trim come in standard lengths.

What if I measure wrong?

Panels made to length are usually non-returnable. Double-check your cut list, or send plans or a roof report so the lengths can be checked.

Is trim made to length too?

Most trim comes in standard lengths, usually about 10′. Custom-bent trim is made to your drawing. See Trim and flashing.