Roofing, siding and metal building materials for contractors, builders and designersServing the U.S.
Home › Resources › Product guides

Product guides

Typical profiles, spec ranges and installation basics for every product category. Generic ranges for planning and comparing; exact specs for your products are in your account.

team reviewing plans and samples

Metal panel profiles

Side views of the most common metal roof and wall panel profiles. Drawings are not to scale; rib heights and spacing vary by manufacturer.

R-panel / PBRTrapezoid ribs about 1¼″ tall, 12″ apart. 36″ coverage.
Ag rib panelShorter ribs about ¾″ tall, about 9″ apart. 36″ coverage.
5V-crimpFive V-shaped ribs. 24″ coverage. Over solid decking.
CorrugatedRounded wave ribs in several sizes, ¾″ to 2½″ wide.
Standing seamFlat pans with raised seams 1″ to 3″ tall. Hidden fasteners.
Board and battenWide flat boards with narrow raised battens. Siding.

Quick reference by category

Category Typical gauges Typical coverage or size Typical minimum roof pitch Guide
Metal roofing panels 29, 26, 24 24″ to 36″ wide 1:12 to 3:12 by profile Metal roofing panels
Standing seam 26, 24, 22 12″ to 24″ wide ¼:12 to 3:12 by system Standing seam
Stone-coated steel 26 About 25 to 29 panels per SQ About 3:12 Stone-coated steel
Tile and slate n/a Varies by tile 2.5:12 to 4:12 Tile and slate
Shingles n/a 3 to 4+ bundles per SQ 2:12 with extra underlayment, 4:12 standard Shingle roofing
Low-slope membranes 45 to 90 mil Rolls; widths vary ¼:12 Low-slope and commercial
Steel framing 20 to 12 4″ to 12″ deep n/a Steel framing
Metal siding 29, 26, 24 12″ to 36″ wide n/a (walls) Metal siding and soffit
Trim and flashing 29, 26, 24 About 10′ lengths n/a Trim and flashing
Underlayment n/a 1 to 10 SQ per roll By roof type Underlayment and ventilation
Fasteners n/a #9 to #14 screws n/a Fasteners and accessories
Insulation n/a R-4 to R-7 per inch (foam board) n/a Insulation and coatings

SQ = one roofing square, 100 sq ft of roof. All figures are typical ranges across manufacturers. Exact specs vary by product.

Installation basics for every roof

  • Follow the manufacturer's instructions. They decide fastener patterns, laps, minimum pitch and warranty coverage.
  • Start with a sound deck or frame. Replace soft or damaged decking and check framing is straight.
  • Underlayment matters. It's the backup layer that keeps water out when wind drives rain under the roofing.
  • Flash every edge and opening. Most leaks start at walls, chimneys, valleys, vents and skylights, not in the open field of the roof.
  • Ventilate the attic. Balanced intake and exhaust helps the roof and underlayment last longer.
  • Use matching parts. Trim, fasteners and accessories from the same system match in color and are tested together.
  • Check local code. Wind, fire, energy and HOA rules can change what's allowed.

Documents in your account

Once your account is approved and you request a quote, your account holds the documents for the exact products quoted:

  • Manufacturer spec sheets and data sheets
  • Installation guides and details
  • Warranty documents
  • Code approvals and test reports (wind, fire, impact)
  • Color charts with exact color names

Log in or request an account