Side by side
| TPO | PVC | EPDM | Modified bitumen | |
|---|---|---|---|---|
| Material | Thermoplastic sheet | Thermoplastic sheet | Synthetic rubber sheet | Asphalt with polyester or fiberglass |
| Typical color | White, tan, gray | White, gray | Black or white | Black or granule-surfaced |
| Seams | Hot-air welded | Hot-air welded | Tape or adhesive | Torch, cold adhesive or self-adhered |
| Reflective | Yes (white) | Yes (white) | Black: no; white: yes | Reflective cap sheets available |
| Chemical and grease resistance | Fair | Very good | Poor with oils | Fair |
| Puncture and traffic | Good | Good | Fair | Very good |
| Relative cost | $$ | $$$ | $$ | $$ |
| Typical lifespan | 20 to 30 years | 20 to 30 years | 25 to 30+ years | 20 years |
Typical ranges. Lifespan depends on thickness, installation, climate and maintenance.
Which fits your building?
- Warehouses, retail and offices in hot climates: white TPO is the most common choice; it reflects heat and the welded seams are strong.
- Restaurants and industrial roofs: PVC, because it holds up to grease, oils and chemicals.
- Large, simple roofs and re-roofs: EPDM, with very large sheets and few seams.
- Small roofs, high foot traffic and repairs: modified bitumen, which is tough and familiar to most crews.
Thickness
Membranes are measured in mils (thousandths of an inch). Thicker membranes cost more and usually last longer:
- 45 mil: budget and short-term roofs
- 60 mil: the most common
- 80 to 90 mil: longer life, more traffic
Don't forget the rest of the system
- Insulation: usually polyiso, sometimes tapered for slope
- Cover board: protects insulation and gives a firm base
- Attachment: mechanically attached, fully adhered or induction welded
- Flashing: curbs, walls, drains, pipes and edges, in the same membrane
- Edge metal: drip edge, gravel stop and copings
