Roofing, siding and metal building materials for contractors, builders and designersServing the U.S.
Home › Resources › Ordering trim and custom bends

Ordering trim and custom bends

How to work out how much trim a job needs, and how to send a drawing for custom-bent trim.

inspecting roof trim

Counting standard trim

Most trim comes in pieces about 10′ long. Pieces overlap at the joints, usually 2″ to 4″, so each piece covers a little less than its full length.

Pieces needed = total length ÷ coverage per piece, rounded up.

Example: 120′ of eave with 10′ 2″ pieces and 4″ laps: each piece covers about 9′ 10″. 120 ÷ 9.83 = 12.2, so order 13 pieces.

Add a few extra for cuts, corners and mistakes.

What to measure

Trim Measure
Eave trim / drip edge Total length of all eaves
Rake / gable trim Total length of all rakes (sloped edges)
Ridge cap Total length of ridges
Hip cap Total length of hips
Valley flashing Total length of valleys
Sidewall / endwall flashing Length where the roof meets a wall, along the slope or across
Corner trim Height of each outside and inside corner
Window and door trim Width and height of each opening
Base trim Total length of the bottom of the walls

A roof measurement report lists most of these lengths.

Drawing custom trim

Custom trim is bent from flat sheet to your drawing. A good drawing shows:

  1. Each flat section with its width, for example 4″, 1″, 6″
  2. Each bend with its angle, for example 90°, 135°
  3. Which side is painted, so the color faces out
  4. Hems (folded edges) where needed, for stiffness and a safe edge
  5. The total length of each piece and how many

The total of all flat widths is the girth, which is used to price custom trim.

Sketch it on paper, take a clear photo and attach it to your quote request. Include a photo of where it goes if you can.

Tips

  • Order trim with the panels, from the same paint system, so colors match.
  • Add hems to exposed edges for a cleaner look and safer handling.
  • For matching old buildings, send a photo, measurements and a piece of the existing trim if possible.

Related